| 1. | Isolated boost converter inrush current occur during flyback work
起动电流过冲发生在flyback工作阶段。 |
| 2. | Study on stability and bifurcation of the current feedback controlled boost converter
变换器的稳定性及分岔研究 |
| 3. | Numerical study of two - parameter bifurcations for the discontinuous current - programmed buck - boost converters
变换器二参数分岔的数值研究 |
| 4. | The main research contents of this dissertation have two parts : isolated boost converter and flyback inverter
本文研究了两部分内容:隔离boost变换器和反激逆变器。 |
| 5. | Besides , the design procedure and power loss analysis were given for a buck - boost converter of 540kw 27 - 270vdc / 28vdc
接着,本文给出了540w27 - 270vdc / 28vdc变换器的设计过程,并进行了损耗分析。 |
| 6. | The start process of isolated boost converter is divided into three stages : flyback work , buck work and boost work
2 )电压电流双闭环控制隔离boost变换器起动过程分flyback工作、 buck工作、 boost工作三个工作阶段。 |
| 7. | Through comparison of characteristics for different dc / dc topologies , buck - boost converter was selected as main topology of the power system
在充分考虑不同dc / dc变换器拓扑特点的基础上,本文选用了buck - boost作为系统的主电路拓扑。 |
| 8. | This paper comprehensively summarizes the typical topologies of isolated boost converter family , and classifies existing topologies into several categories
本文对隔离boost变换器的发展作了系统的总结和分类,并详细讨论了它们的特点。 |
| 9. | Some characteristic simulation of the whole circuit were finished and analyzed later . the efficiency of the boost converter achieves 80 %
在子电路模块设计完成之后对boost电路的整体特性进行了仿真,并根据仿真结果对子电路模块参数进行微调,调整后的整体电路经仿真效率达到80 % 。 |
| 10. | Then , a peak current control pfm dc - dc boost converter was presented , which integrated with under voltage , over voltage , current limit and soft start protecting blocks
然后,根据当前功率集成电路的现状和发展趋势,论文设计了一种基于升压型pfm调制方式的dc - dc电源转换控制芯片。 |
